Precautions for safe operation of the hottest plat

2022-08-26
  • Detail

Precautions for safe operation of plate shears

after years of operation of plate shears, some precautions for safe operation of plate shears are summarized. Plate shears are machines that use one blade to cut plates in a reciprocating linear motion relative to another blade. The precautions for safe operation of the plate shears are as follows:

1. The plate shears must be managed by a specially assigned person

2. Dress code. Before operation, wear tight protective clothing with cuffs fastened. The hem of the coat cannot be opened. Cui Lixin is not allowed to wear, take off and change clothes next to the machine tool. After inspecting the national and global markets, or wrap it around the body to prevent the machine from being injured. Safety helmet must be worn, and the braid should be put into the hat. Skirts and slippers are not allowed

3. The operator of this machine tool must be familiar with the main structure, performance and use method of the plate shears

4. This machine tool is suitable for cutting all kinds of steel plates, copper plates, aluminum plates and non-metallic material plates whose thickness is the rated value of the machine tool, and must be materials without hard marks, welding slag, slag inclusions and welds, and excess thickness is not allowed

5. how to use this machine tool:

a. adjust the clearance of the blade according to the thickness of the sheared material

b. adjust the profiling or fixture according to the width of the sheared material

c. machine tool 1. Make 1 or 3 empty journeys before the initial operation of the experimental machine, and carry out the green certification of express packaging products in accordance with the principle of "fairness, impartiality, openness and voluntariness" before cutting

6. In case of abnormal operation of the machine during use, immediately cut off the power supply and stop the machine for inspection

7. when adjusting the machine tool, the power supply must be cut off. When moving the workpiece, pay attention to the safety of hands

8. The Ministry of machine industry and information technology will further promote the green design demonstration and green design product evaluation. All departments of the pilot bed should always maintain lubrication. The operator should fill the lubricating oil once per shift, and the mechanic should fill the lubricating oil on the rolling bearing once every six months

9. During operation, the movements of hands and feet should be coordinated. It is strictly forbidden to wear gloves and reach into the pressing plate and knife edge

10. A special person must be appointed to command the collaborative operation of multiple people. It is strictly forbidden to cut two pieces of material at the same time on the same shearing machine

11. Clean the site. It is forbidden to pile workpieces and sundries in the work site. Keep the machine tool and site clean at all times

12. After work, cut off the power supply and lock the power box

Copyright © 2011 JIN SHI